TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 204 of 772
TM 9-2350-260-20-1-2 ENGINE OIL COOLER REPLACEMENT (2A ENGINE) (Sheet 8 of 8) 15. Position two new gaskets (S) on engine oil cooler (C). 16. Remove tape and plastic and position engine oil cooler connectors (T) and (U) on oil cooler (C). 17. Using 1/2 inch socket, install six new self-locking nub (V) securing two engine oil connectors (T) and (U) to engine oil cooler (C). 18. Remove masking tape and plastic from hoses (W) and (X). 19. Using 1-1/2 inch wrench, install hose nut (W) to connector (U). 20. Using 1-1/2 inch wrench, install hose nut (X) to connector (T). 22. Replenish lubricating oil lot during engine oil cools replacement (LO 9-2350-260-12). Start and run engine. 23. Ground hop engine (page 5-54). Check for oil leaks at oil cooler and hose connections. Tighten any connections that are leaking. 24. Stop engine and disconnect ground hop kit (page 67). 25. Install powerplant (page 5-14). End of Task TA147578 6-127