TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 197 of 772
TM 9-2350-260-20-1-2 ENGINE OIL COOLER REPLACEMENT (2A ENGINE) (Sheet 1 of 8) PROCEDURE INDEX PROCEDURE PAGE Removal 6-121 Installation 6-125 TOOLS: 1/2 in. socket with 1/2 in. drive 9/16 in. combination box and open end wrench 1-1/2 in. combination box and open end wrench 9/16 in. socket with 1/2 in. drive Ratchet with 1/2 in. drive Slip joint pliers Putty knife Diagonal cutting pliers 1-3/4 in. open end wrench SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I) SUPPLIES: Lockwire (Item 60, Appendix D) Engine oil cooler connector gaskets (8682679) (2 required) Thermostatic bypass valve gasket (7403580 Drip pan Roll of masking tape, 1/2 in. wide (Item 57, Appendix D) Plastic barrier material (Item 41, Appendix D) Self-locking nut (MS21045-5) (6 required) REFERENCES: TM 9-2350-260-10 LO 9-2350-260-12 PRELIMINARY PROCEDURES: Remove powerplant (page 5-1) Go on to Sheet 2 6-120