TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 186 of 772
TM 9-2350-260-20-1-2 POWERPLANT LEFT BANK OIL COOLER FRAME AND BRACKETS REPLACEMENT (2D ENGINE) (Sheet 3 of 9) 8. Using 1/2 inch socket and 1/2 inch wrench, remove two capscrews and self-locking nuts (L). Throw self-locking nuts away. 9. Remove bracket (M) with harness attached from frame. 5. Using 1/2 inch socket, remove screw and clamp (H). 6. Using 1/2 inch socket with extension and 1/2 inch wrench, remove two screws and nuts (J). 7. Remove ignition unit (K) with clamps and leads from frame. 10. Using 9/16 inch socket and 9/16 inch wrench, remove eight capscrews and self-locking nuts (N). Use 9/16 inch wrench to keep nuts from turning. Throw self-locking nuts away. 11. Using 1/2 inch socket with extension, remove five screws (P). 12. Using 1/2 inch socket and 1/2 inch wrench, remove screw and self-locking nut (Q). Throw self-locking nut away. NOTE It may be necessary to pull frame (R) out before oil cooler support frame (S) can be removed. Go on to Sheet 4 TA147561 6-109