TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 185 of 772
TM 9-2350-260-20-1-2 POWERPLANT LEFT BANK OIL COOLER FRAME AND BRACKETS REPLACEMENT (2D ENGINE) (Sheet 2 of 9) NOTE Because of space limitations, it may be necessary to interchange like-size sockets and wrenches to get at a particular screw. REMOVAL: NOTE It may be necessary to use screwdriver and 3/8 inch wrench to remove clamp (A) and move tube (B) before fuel-water separator filter (C) can be lowered. 1. Using 1/2 inch socket, remove four capscrews, lockwashers, and flat washers (D). Throw lockwashers away. 5. Using 1/2 inch socket, remove screw and clamp (H). 6. Using 1/2 inch socket with extension and 1/2 inch wrench, remove two screws and nuts (J). 7. Remove ignition unit (K) with clamps and leads from frame. 2. Lower fuel-water separator filter (C) away from mounting bracket (E). 3. Using 5/8 inch socket, remove three screws (F) securing mounting bracket (E) to engine. Remove mounting bracket (E). 4. Using 1/2 inch socket, remove three assembled washer bolts (G). Go on to Sheet 3 TA147560 6-108