TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 129 of 772
TM 9-2350-260-20-1-2 CYLINDER HEAD AND OIL PAN DRAIN TUBES (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4) PROCEDURE INDEX PROCEDURE PAGE Removal 6-52 Inspection 6-53 Installation 6-54 TOOLS: 7/8 in. socket with 1/2 in. drive Diagonal cutting pliers Flat-tip screwdriver Slip joint pliers 1/2 in. socket with 1/2 in. drive 3/8 in. combination box and open end wrench Ratchet with 1/2 in. drive SUPPLIES: Lockwire (Item 59, Appendix D) Gasket (8682772) Lockwasher (7410218) (2 required) SPECIAL TOOLS: Ground hop kit (Item 32, Chapter 3, Section D REFERENCE: LO 9-2350-260-12 PRELIMINARY PROCEDURE: Remove powerplant (page 5-1) Drain engine oil (2A engine, page 6-47) (2D engine, page 6-49) Remove powerplant left bank oil cooler frame and brackets (2D engine, page 6-108) (as required) Remove powerplant right bank oil cooler frame and brackets (2D engine, page 6-99) (as required) Remove powerplant oil coolers frame and brackets (2A engine, page 6-94) REMOVAL: 1. Using 1/2 inch socket, remove two bolts and lockwashers (A). Throw lockwashers away. 2. Remove gasket (B) and throw away. Go on to Sheet 2 TA147506 6-52