TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 126 of 772
TM 9-2350-260-20-1-2 DRAIN ENGINE OIL (2D ENGINE) (Sheet 1 of 3) TOOLS: 9/16 in. socket with 3/8 in. drive 10 in. extension with 1/2 in. drive Torque wrench with 3/8 in. drive (0-200 lb-in) (0-23 Nm) Ratchet with 1/2 in. drive Flat-tip screwdriver Putty knife 9/16 in. combination box and open end wrench 3/4 in. socket with 1/2 in. drive SUPPLIES: Container to catch oil (minimum 20 gal. capacity) Gasket (11684054) Sealing washer (NAS1598-6Y) Rags (Item 65, Appendix D) Lockwashers (MS35338-67) (4 required) REFERENCES: LO 9-2350-26042 TM 9-2350-260-10 PRELIMINARY PROCEDURES: Open rear drain valve (TM 9-2350-260-10) Remove upper engine access cover (page 16-44) WARNING Hold valve seat (A) up when removing last screw (B) attaching valve seat (A) to hull floor (C). Valve seat (A) is heavy and can cause injury if it falls. 1. Using 3/4 inch socket, remove four screws (B) and lockwashers (D) holding valve seat (A) and gasket (E) to hull floor (C). Throw lockwashers away. 2. While holding valve seat (A), use screwdriver and pry valve seat (A) from hull floor (C). 3. Using putty knife, scrape gasket (E) from hull floor (C) and valve seat (A). Throw gasket away. Go on to Sheet 2 TA147503 6-49