TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 125 of 772
TM 9-2350-260-20-1-2 DRAIN ENGINE OIL (2A ENGINE) (Sheet 2 of 2) 4. Position container under drain valve opening. 5. Cut lockwire from drain plugs (F). 6. Using ratchet and extension, remove two oil drain plugs (F) from engine oil pan (G). 7. Allow engine oil to drain into container. 8. After draining, using rags (Item 65, Appendix D), clean area around drain plugs (F) and, using ratchet and extension, install drain plugs (F) into engine oil pan (G). 9. Using lockwire (Item 59, Appendix D), safety wire drain plugs (F). 10. Refill crankcase (LO 9-2350-260-12). 11. Line up four holes in valve seat (A), new gasket (E), and hull floor (C) under tank. 12. Using 3/4 inch socket install four screws (B) and new lockwashers (D) holding valve seat (A) and gasket (E) to hull floor (C). 13. Operate rear drain valve to make sure valve opens and closes smoothly. If valve does not open or close properly, remove, inspect and install valve assembly again. End of Task TA147502 6-48