TM-9-2350-260-20-1-2 M60 Hull Organizational Maintenance Volume 2 Download
Page 124 of 772
TM 9-2350-280-20-1-2 DRAIN ENGINE OIL (2A ENGINE) (Sheet 1 of 2) TOOLS: 3/4 in. socket with 1/2 in. drive 10 in. extension with 1/2 in. drive Diagonal cutting pliers Ratchet with 1/2 in. drive Flat-tip screwdriver Putty knife SUPPLIES: Container to catch oil (minimum 20 gal. capacity) Gasket (7320462) Lockwire (Item 59, Appendix D) Rags (Item 65, Appendix D) Lockwasher (MS35338-67) (4 required) REFERENCE: LO 9-2350-260-12 WARNING Hold up valve seat (A) when removing last screw (B) attaching valve seat (A) to hull floor (C). Valve seat (A) is heavy and can cause injury if it falls. 1. Using 3/4 inch socket, remove four screws (B) and lockwashers (D) holding valve seat (A) and gasket (E) to hull floor (C). Throw lockwashers away. 2. While holding valve seat (A), use screwdriver and pry valve seat (A) from hull floor (C). 3. Using putty knife, scrape gasket (E) from hull floor (C) and valve seat (A). Throw gasket away. Go on to Sheet 2 TA147501 6-47