TM-9-1240-382-34P M35E1 Periscope Direct and General Maintenance and Parts Manual Download
Page 6 of 77
TM 9-1240-382-34P Code Definition MO ................Item to be manufactured or fabricated at organizational level. MF.................. Item to be manufactured or fabricated at the direct support maintenance level. MH ................Item to be manufactured or fabricated at the general support maintenance level. MD .................Item to be manufactured or fabricated at the depot maintenance level. AC.................. Item to be assembled at organizational level. AF ................. Item to be assembled at direct support maintenance level. AH.................. Item to be assembled at general support maintenance level. AD .................Item to be assembled at depot maintenance level. XA .................. Item is not procured or stocked because the requirements for the item will result in the replacement of the next higher assembly. XB .................. Item is not procured or stocked. If not available through salvage, requisition. XC.................. Installation drawing, diagram, instruction sheet, field service drawing, that is identified by manufacturer’s part number. XD.................. A support item that is not stocked. When required, item will be procured through normal supply channels. NOTE Cannibalization or salvage may be used as a source of supply for any items coded above except those coded XA and aircraft support items as restricted by AR 700-42. (2) Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance authorized to USE and REPAIR support items. The maintenance codes are entered in the third and fourth positions of the Uniform SMR Code format as follows: (a) The maintenance code entered in the third position will indicate the lowest maintenance level authorized to remove, replace, and use the support item. The maintenance code entered in the third position will indicate one of the following levels of maintenance: Code Application/explanation C .................... Crew or operator maintenance performed within organizational maintenance. C .................... Support item is removed, replaced, used at the organizational level. F .................... Support item is removed, replaced, used at the direct support level. H ................... Support item is removed, replaced, used at the general support level. D .................... Support items that are removed, replaced, used at depot, mobile depot, or specialized repair activity only. (b) The maintenance code entered in the fourth position indicates whether the item is to be repaired and identifies the lowest maintenance level with the capability to perform complete repair (i.e., all authorized maintenance functions). This position will contain one of the following maintenance codes: Code Application/explanation 0 .................... The lowest maintenance level capable of complete repair of the support item is the organizational level. F .................... The lowest maintenance level capable of complete repair of the support item is the direct support level. H .................... The lowest maintenance level capable of complete repair of the support item is the general support level. D .................... The lowest maintenance level capable of complete repair of the support item is the depot level. L .................... Repair restricted to specialized repair activity. Not applicable. Z ................... Nonreparable. No repair is authorized. B .................... No repair is authorized. The item may be reconditioned by adjusting, lubricating, etc., at the user level. No parts or special tools are procured for the maintenance of this item. (3) Recoverability code. Recoverability codes are assigned to support items to indicate the disposition action on unserviceable items. The recoverability code is entered in the fifth position of the Uniform SMR Code format as follows : 2