TB-9-2300-378-14 Technical Bulletin for Air Induction System M48 M60 Download
Page 83 of 296
TB 9-2300-378-14 (1) Parts Required. Table 4-3 lists the parts required to fabricate the ground hop filter. Table 4-3. Ground Hop Filter Parts Nomenclature Filter element Hose assembly (on engine) 1/4" thick x 13-7/8" dia. aluminum plate 5/16" dia. x 45-1/2" long cold rolled steel rod 1/16" thick x 5-3/4" dia. rubber sheet 3/8" washer, plain Chain (11 inches) 1/4" 20 x 3/4 screws 1/4" washer, plain 5/16" 18 wing nut 1/8" welding rod Part No. 11604545 11655240 MS27183-15 MS35275-281 MS27183-10 MS35425-39 NSN 2940-00-134-4657 4720-00-614-8390 5310-00-809-4061 4010-00-129-3881 5305-00-939-9147 5310-00-809-4058 5310-00-080-8495 Qty 2 2 2 4 2 12 2 12 12 8 As Req’d (2) Retainer (4 required). Fabricate as follows: (a) Using steel rod, bend to dimensions (view A). (b) Using 5/16-18 die, thread each rod end a minimum of 2 inches. (3) Gasket (2 required). Using 1/16 rubber sheet, fabricate gaskets as described in view B. (4) Handle (2 required). Using length of chain welding rod and washer, fabricate chain end as follows: (a) Bend 1/8 inch welding rod to shap (view C). (b) Weld rod to edge of washer on one side. (c) Install chain. 4-23