TB-9-2300-378-14 Technical Bulletin for Air Induction System M48 M60 Download
Page 67 of 296
(a) Using 9/16 wrench, housing (view A). TB 9-2300-378-14 loosen remaining captive screws securing access door to (b) Position a block (2 x 4 x 18) of wood across fender storage box so access door will rest on block of wood when door is opened. Open access door allowing it to rest firmly against block of wood. Block (c) must be positioned to inside of captive screw(s) (view B). (d) Remove filter element, cover, and store temporarily in a safe place. (e) (f) (g) (h) Using tape and cardboard or a large cloth, cover housing opening (so dirt cannot fall into box). (Do not cover housing bolt holes.) Using a hammer and punch drive pin, drive out damaged captive screw(s) (view C). Remove tape, cardboard or cloth from housing opening. Using a damp clean rag, wipe inside of filter housing removing any dirt or metal chips. Install filter element, make sure all seals and gaskets are in place. Carefully close access door (view B). — CAUTION It may be necessary for mechanic to kneel on access door to start screws. Make sure screws are fully engaged before releasing weight from access door or hole threads will be stripped. (i) (j) 4-4. Air Cleaner a. b. Install three new screws PN 12290914, NSN 5306-01-091-3384 in access door and finger tighten (view D). Using torque wrench, tighten three screws, starting with middle, to 40-48 lb-ft (54-65 N·M). Repeat procedure for opposite air cleaner. Filter Clog Indicator Rework General. The following procedures to rework the air cleaner outlet elbow to accept the late model filter clog indicator. Rework Procedure. (1) Tools and Equipment Required: (a) Hacksaw (b) Scribe (c) 1/8 - 27 NPTF tap (d) Electric drill with a 90° drive angle with a 3/8 inch chuck 4-7