TB-9-2300-378-14 Technical Bulletin for Air Induction System M48 M60 Download
Page 112 of 296
TB 9-2300-378-14 (5) (6) (7) (8) (9) (lo) (11) (12) (13) (14) (15) Using B). Tape Figure 4-27. Template fabrication rule and scribe, scribe left and right vertical guide bars as indicated (view cardboard to air outlet port to prevent cutting and grinding debris from entering engine. WARNING Use approved eye protection prevent serious eye injury. Using hand grinder with cutting guide bar. Cut through weld on backside of bar. during wheel, grinding operations to cut along scribed lines through vertical guide bar between cut-off line and lower end of Replace cut-off wheel with grinding wheel and remove remaining weld in cut-off area. Using rags and vacuum cleaner, remove cutting and grinding operation debris. Prime and paint bare metal areas. After paint has dried, wipe and vacuum inside of air cleaner housing to remove paint overspray residue. Remove cardboard and tape from air outlet port. Inspect door seal. Replace if defective (TM-20). Install air cleaner filter element (TM-20). 4-52