MWO-9-2300-378-34-2 Maintenance Work Order for M60 Smoke Generation Download
Page 75 of 92
MWO9-2300-378-34-2 (6) Check for plugged, pinched or damaged fuel tube assemblies. b. Smoke produced is of poor quality or quantity. (1) Check for fuel running out of hull drains, indicating a ruptured fuel line or loose connect ion. (2) Check for plugged, pinched, or damaged fuel tube assemblies. (3) Check engine fuel filters, replace as necessary. c. Vehicle smokes when smoke generator is not activated. (1) Check for voltage at solenoid valves. If voltage is indicated, check wiring harness and bulkhead connectors for short. (2) Check solenoid valves. Replace solenoid valves if they do not shut off fuel flow. 11. CALIBRATION REQUIREMENTS None. 12. WEIGHT AND BALANCE DATA Weight and balance are not significantly affected. 13. QUALITY ASSURANCE REQUIREMENTS General. The following information is supplied to insure the proper application of this MWO The provisions include physical inspection, a post installation functional check and troubleshooting. b. Physical Inspection. Check components that were removed or installed during the MWO for security of mounting, paying close lead assemblies for proper and neat routing. c. Post Installation Functional Check. attention to. the fuel lines. Inspect harness and OPERATION Start the engine Operate engine generator. The white smoke. and bring it up to operating temperature. at 1600 rpm and activate the smoke left and right exhaust pipes should emit Never activate smoke generator in a building or closed area or with personnel near. 73