MWO-9-2300-378-34-2 Maintenance Work Order for M60 Smoke Generation Download
Page 16 of 92
MWO 9-2300-378-34-2 10. MODIFICATION PROCEDURES The smoke generating system is only intended to be used on vehicles with AVDS-1790-2C and AVDS-1790-2D engines which have electrical disconnection top of the engine. The installation instructions for the engine portion of the system will be the same for all the vehicles intended to be modified. However, there are different installation instructions for the hull wiring portion of the various vehicles. These instructions will be divided into eight sections as follows: Section I Section II Section III Section IV Section V Section VI Section VII Section VIII Engine Modification Instructions Assembly of Smoke Generator Switch Bracket Hull Wiring Instructions for M60A3 and M60A1 (RISE) Vehicles Hull Wiring Instructions for M60A1 and M728 Vehicles Hull Wiring Instructions for the M48A5 Vehicle Hull Wiring Instructions for the M60A1 AVLB and the M48A5 AVLB System Operation and Leak Check Troubleshooting Section I - a. Preliminary Procedures. (1) Disconnect the three ground appropriate vehicle TM). (2) Remove powerplant (refer to (3) Remove engine shroud and vehicle TM). Engine Modification straps from the battery negative terminals (refer to appropriate vehicle TM). rear engine shroud support (refer to appropriate 14