TM 9-2910-226-34 Install cotter pin from bottom and spread prongs tightly around the rod pin screw. NOTE After assembly, place fulcrum lever in vertical position. Raise fuel control rod to a horizontal position. When free, fuel control rod should drop slowly of its own weight. NOTE Paragraphs (4), (5) and (6) do not apply to code A injection pumps. (4) Refer to figure 3-74 and install fulcrum lever assembly in governor housing. Fulcrum lever pivot pins must have a dimension (X) (fig. 3-67) of 0.165. Figure 3-73. Adjusting smoke limit cam angle. Figure 3-74. Installing fulcrum lever and associated-sin governor housing. 3-50