TM 9-2910-226-34 Figure 3-65. Removing or installing torque link assembly in governor housing (code A pumps). (14) Refer to figure 3-66. Remove two lock pins (A) and two outside washers (B). Separate operating shaft assembly (D) from torque link assembly (C). Remove two inside washers (B) from pins (E). Remove and discard operating shaft packing (F). Remove fuel limiting stop from torque link by removing cotter pin (G), outside flat washer (H), stop (J), inside flat washer (H) and spring washer (K). Figure 3-66. Disassembling or assembling of torque link assembly (code A pumps). 3-44