TM 9-2910-226-34 Figure 3-52. Inspecting fuel density compensator brass plug for leakage. (5) Check compensator for fuel leakage around the piston shaft and at the brass plug under the stop plate guide (fig. 4-52). A trace of fuel iS permissible) but if a drop forms, replace the compensator. (6) If compensator operation meets this test, no further inspection is necessary. (7) If compensator operation does not meet this test, replace with a new unit. c. If compensator 2910-907-0665 is equipped with an undrilled link and a push nut in place of drilled link (A), washer (B) and pin (C) fig. 3-53, discard nut and modify link as shown in figure 3-53, by drilling a hole and using the desired washer and pin. Figure 3-53. Modification of fuel density compensator fuel control link. 3-25. Repair of Governor Assembly. a. Disassembly. Disassemble the governor assembly as follows: (1) Refer to figure 3-54. Cut locking wire (A) and remove two capscrews (B) and lockwashers (C). Remove governor end cap (D). Remove and discard cap gasket (E). Figure 3-54. Removing governor end cap. 3-38