TM 9-2910-226-34 Figure 3-27. Removing bearing retaining plate. b. Refer to figure 3-28. Place the pump housing (A) on bed of arbor press. Position remover and replacer on camshaft (B) and press the camshaft and associated parts from the pump housing. Figure 3-28. Pressing camshaft and associated parts from pump housing using remover and replacer 5120-793-5055. Caution Support the pump housing so that the timing pointer (fig. 3-27) will not be damaged. Section Ill. REPAIR OF FUEL INJECTION PUMP COMPONENTS 3-17. General. a. Parts Identification. Because of the numerous pump models repaired in this section of the manual a ready reference to parts is provided in table 3-1. Parts in appendix B are coded the same as the pumps. (1) Column 1, nomenclature. Defines pump and part name. (2) Columns 2 through 5. These columns list the pumps as coded with the part number of the part applicable to the particular pump. The numbers indicated are the Army number, Federal stock number, and the manufacturer’s part number (American-Bosch, FSCM 01843). (3) Column 6, remarks. Defines differences in parts shown in columns 2 through 6 for the par- ticular part, indicates optional parts, and also shows parts available in kits. b. Illustrations. Figures 3-29 through 3-37 are exploded views of the pumps and show the different parts applications. 3-11