TM 9-2910-226-34 and turn puller screw slowly until the weight and spider assembly is removed from the camshaft. Figure 3-13. Removing governor assembly. 3-11. Removal of Governor Weight and Spider Assembly. Refer to figure 3-14. Position remover and replacer against the camshaft shoulder. If the remover and replacer does not clear the governor weight fingers, rotate the friction drive spider while keeping the camshaft stationary. Install the puller, Figure 3-14. Removing governor weight and spider assembly using puller 5120-793-5048 and remover and replacer 5120-793-5055. 3-12. Removal of Timing Device Assembly. a. Refer to figure 3-15. Disconnect and remove oil hose assembly (A), pipe-to-tube tee (B), pipe-to-tube elbow (C) and hex nipple (D). Remove two capscrews (E), Iockwashers (F) and flat washers (G). Remove timing device assembly (H). Remove and discard preformed packing (J). Figure 3-15. Removing timing device assembly. 3-6