TM 9-2910-226-34 (2) Refer to figure 3-11. Remove two capscrews (A), lockwashers (B), and flat washers (C). Remove stop plate and bridge assembly (D). (3) Refer to figure 3-12. Remove nut (A), lock- washer (B), stop plate bridge (C), lockwasher (D) and nut (E) from stop plate. Figure 3-11. Removing stop plate and bridge assembly (code G pumps). Figure 3-12. Disassembling stop plate and bridge assembly (code G pumps). 3-10. Removal of Governor. Refer to figure 3-13. Cut lockwashers (E). Remove governor housing and locking wire (A) and remove three capscrews (B), associated parts (F). Remove and discard governor lockwashers (C), and two machine screws (D) and housing gasket (G). 3-5