TM 9-2910-226-34 pensator assembly and gasket (J) from governor housing. Discard gasket, compensator assembly, tube and hose as this compensator assembly 2910- 017-9776 will be replaced with compensator assembly 2910-907-0665. (2) Code A, B, C, D, E and late F injection pumps. Refer to figure 3-8. Remove tube assembly (A) from tee and from elbow in hydraulic head. Disconnect tubing (B) from elbow. Remove and discard locking wire and seal (C). Remove four capscrews (D), lockwashers (E), tamper proof cover (F) and clip securing compensator to governor housing. Tap fuel density compensator (G) with a soft hammer to break gasket seal and remove fuel density compensator assembly (G) and gasket (H) from governor housing. Discard gasket and retain compensator assembly for possible repair. Figure 3-8. Removing fuel density compensator (code A, B, C, D, E and late code F pumps}. (3) Code A injection pump compensators. Refer to figure 3-9. Compensator 2910-125-3793 uses an additional fuel limiting stop. This stop (A) is at- tached to the torque link (b), and is furnished with new compensator. Figure 3-9. Removing fuel density compensator (code A pumps). c. Removal of Governor Cover and Stop Plate and Bridge Assembly. NOTE Paragraphs (1) through (3) below refer to code G injection pumps only. (1) Refer to figure 3-10. Remove four machine screws (A) and lockwashers (B). Remove governor cover (C). Remove and discard cover gasket (D). Figure 3-10. Removing governor cover (code G pumps). 3-4