TM 9-2910-226-34 Figure 1-12. Metering and distributing fuel injection pump assembly (code A), right rear view. 1-2. Maintenance Forms and Records. Maintenance improvements. Your letter or DA Form 2028 forms and records that you are required to use are (Recommended Changes to Publications and Blank explained in TM 38-750. Forms) should be mailed direct to Commander, 1-3. Recommendation for Maintenance Publications US Armv Tank-Automotive Command, ATTN: Improvements. You can help to improve this manual AMSTA-M, Warren, MI 48090. A reply will be by calling attention to errors and by recommending furnished direct to you. Section Il. DESCRIPTION AND DATA 1-4. Localization of Fuel Injection Pump Com- C. As viewed from the governor end, the side on ponents. a. In this manual, the terms defined in b the viewer’s right will be the right side. and c below will be used to describe the location of 1-5. General. a. The metering and distributing fuel the fuel injection pump components. infection pump assembly is a constant-stroke, b. The timing device end of the pump will be distributing-plunger, sleeve control type. The called the front and the governor end the rear. plunger is actuated by a camshaft and tappet 1-13