TM 9-2910-226-34 Figure 3-157. Checking stop plate and smoke limit cam clearance (code G pumps). (3) Refer to figure 3-158. Install governor cover gasket (A) and governor cover (B). Secure cover with four machine screws (C) and Iockwashers (D). Torque tighten screws to 50-60 inch-pounds. NOTE If the fuel pump is to be tested immediately after assembly, the governor cover should not be secured until adjustments are made as described in paragraphs 3-50 through 3-58. Figure 3-158. Installing governor cover (code G pumps). 3-47. Installation of Timing Window Cover and Fuel Shutoff Rod Assembly or Solenoid Assembly. a. Assembly. The timing window cover and fuel shutoff rod assembly were assembled during repair (paras. 3-21 and 3-22). b. Installation. Refer to figure 3-159. Coat gasket (A) with a thin coat of sealer, MIL-S-45180 or equivalent on side facing cover. Install gasket (A), timing window cover and fuel shutoff rod assembly (B). Install two fillister head screws (C) and lock- washers (D). NOTE If the injection pump is to be tested after assembly, do not tighten the timing window screws until the fuel leakage and timing check as described in paragraphs 3-50 through 3-58 has been performed. Figure 3-159. Installing timing window cover and fuel shutoff rod assembly or solenoid assembly, Installation of Fuel Shutoff Solenoid Assembly. Install fuel shutoff solenoid assembly the same as in b above except use two socket head screws and lockwashers (E). Do not tighten screws and install wire until after pump is tested. NOTE Gasket – 11662856 (0.020 thick) is a service replacement for gasket — 7748841 (0.031 thick) and can be used with timing window cover on any pump, but is a mandatory replacement with the solenoid assembly on code A injection pump. 3-89