TM 9-2910-226-34 c. Refer to figure 3-115. Insert quill shaft assembly. Figure 3-115. Installing quill shaft assembly. d. Refer to figure 3-116. Install quill shaft assembly so open tooth alines with housing mark (A), Install cop- per gasket (B) and machine screw (C). Torque tighten machine screw to 80-90 inch-pounds and secure with locking wire. e. Refer to figure 3-117. Coat both sides of quill shaft pad gasket with a thin coat of sealer, MIL-S-45180 or equivalent. Install quill shaft pad gasket (A) and quill shaft pad cover (B). Secure cover with two copper gaskets (C) and machine screws (D). Torque tighten ma- chine screws to 50-60 inch-pounds. Screws will be lock wired at governor installation (para 3-43). Figure 3-117. Installing quill shaft pad cover. 3-39. Installation of Tappet Assembly. a. Assembly. The tappet assembly was assembled during repair (para 3-29). NOTE Refer to figure 3-118 for selection of tappet, spring, and spring seat. Figure 3-116. Installing quill shaft assembly in housing. 3-72 Change 2