TM 9-2910-226-34 3-27. Repair of Timing Device Assembly. a. timing device springs (A). Remove Disassembly. end play spacer (C), sliding gear (1) Refer to figure 3-95. Remove the three spider thrust plate (A), and (F). sliding gear (B), spacer (D) and Figure 3-95. Removing sliding gear, spider assembly and associated parts. (2) Refer to figure 3-96. Remove four capscrews b. Inspection and - Repair. Inspect and repair lockwashers (B), and timing cover (C). Remove timing device assembly as follows: discard timing cover gasket (D). (1) Refer to figure 3-97. Check the components of the timing device assembly against the limits specified in the repair standards (para 3-63) and replace the components when they do not meet these requirements. KEY to fig. 3-97 A B C D E G H F J K L M N Q Preformed packing ΒΌ-inch lockwasher 1/4x5/8 machine screw Timing cover Timing cover gasket Thrust plate Weight and spider assembly Housing assembly 1 Bushing type bearing 2 Housing End play spacer Sliding gear spacer Sliding gear Timing device spring Camshaft nut Timing device Camshaft nut setscrew P Figure 3-96. Removing or installing timing cover. 3-60