TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 904 of 968
TM 9-2815-210-34-2-2 Table 6-10. Run-In Schedule - Short (Model LDS-465-2) NOTE During run-in, oil sump temperature shall not be more than 265°F. Oil pressure is measured at engine oil gallery. Gross Brake Fuel Duration Engine Speed Horsepower (DF-1 of Period (minutes) (rpm) (bare engine) VV-F-800) 1 1 0 0 (minimum) Prelubricate at 25 psi (measured at engine oil gallery) 2 10 1400 40 Diesel 3 15 1600 60 Diesel 4 Retighten cylinder head nuts to 157 pound-feet and set valves immediately following period 3. 5 15 2200 120 Diesel 6 10 2800 160 to 190 Diesel 7 Set high speed adjusting screw to limit maximum speed, no load 3050 to 3100 rpm. 8 Set full load 2800 195 to 205 Diesel power (92 lb/hr max. fuel flow) 9 Set droop screw 1200 (37 to 39 Diesel lb/hr fuel or flow) 1400 (44 to 45 Diesel lb/hr fuel flow) 10 Power check full 2000 425 pound- Diesel load feet torque (rein) (70 lb/hr max. fuel flow) 11 Set low idle adjust- 650 to 700 0 Diesel ment 12 As needed to check Diesel for leaks 6-49