TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 901 of 968
TM 9-2815-210-34-2-2 Table 6-7. Run-In Schedule - Short (Model LDT-465-1C) NOTE During run-in, oil sump temperature shall not be more than 265°F. Oil pressure is measured at engine oil gallery. Gross Brake Fuel Duration Engine Speed Horsepower (DF-1 of Period (minutes) (rpm) (bare engine) VV-F-800) 1 1 0 0 (minimum) Prelubricate at 25 psi (measured at engine oil gallery ) 2 10 1200 15 Diesel 3 15 2000 64 Diesel 4 Retighten cylinder head nuts to 157 pound-feet and set valves immediately following period 3. 5 15 2400 110 Diesel 6 10 2600 125 to 135 Diesel 7 Set high speed adjusting screw to limit maximum speed, no load 2850 to 2900 rpm. 8 Set full load 2600 130 to 140 Diesel power (64 lb/hr max. fuel flow) 9 Power check full 1500 305 pound- Diesel load feet torque (rein) (37.5 lb/hr max. fuel flow) 10 Set droop screw 1200 (29 to 30 lb/ Diesel hr fuel flow) 11 Set low idle adjust- Note 1 0 Diesel ment 12 As needed to check Diesel for leaks Note 1: Check injection pump data plate for recommended low idle adjustment setting. 6-46