TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 899 of 968
TM 9-2815-210-34-2-2 Table 6-5. Run-In Schedule- Long (Model LDS-465-2) NOTE During run-in, oil sump temperature shall not be more than 265°F. Oil pressure is measured at engine oil gallery. Gross Brake Fuel Duration Engine Speed Horsepower (DF-1 of Period (minutes) (rpm) (bare engine) VV-F-800) 1 0 0 (minimum) Prelubricate at 25 psi (measured at engine oil gallery) 2 30 1000 22 Diesel 3 15 1400 40 Diesel 4 Retighten cylinder head nuts to 157 pound-feet and set valves immediately following period 3. 5 15 1600 60 Diesel 6 15 2200 120 Diesel 7 30 2800 160 Diesel 8 30 2800 190 to 200 Diesel 9 Set high speed adjusting screw to limit maximum speed, no load 3050 to 3100 rpm. 10 Set full load 2800 195 to 205 Diesel power (92 lb/hr max. fuel flow) 11 Set droop screw 1200 (37 to 39 lb/ Diesel or hr fuel flow) (44 to 45 lb/ Diesel 1400 hr fuel flow) 12 Power check full 2000 425 pound- Diesel load feet torque (min) (70 lb/hr max. fuel flow) 13 Set low idle adjust- 650 to 700 0 Diesel ment 14 As needed to check Diesel for leaks 6-44