TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 720 of 968
TM 9-2815-210-34-2-2 FRAME 4 NOTE Cylinders are called number one through six, counting from front to rear of engine. Each cylinder has one intake valve and one exhaust valve. Intake valve for 1. 2. 3. 4. 5. 6. 7. Turn all each cylinder is toward front of cylinder valve is toward rear of cylinder. 12 adjusting screws (1) in until they just and exhaust touch push rods (2). NOTE While turning in adjusting screws (1), you may have to unscrew locking nuts (3) before adjusting screw can touch push rods (2). Watch push rod (2) which works cylinder number one intake valve. Using engine-barring wrench, turn crankshaft damper and pulley (4) until push rod moves up as high as it will go. Slide 0.010-inch feeler gage between cylinder number two intake rocker arm pad (5) and cylinder number two intake valve stem (6). Turn adjusting screw (1) until feeler gage fits snugly between intake rocker arm pad (5) and intake valve stem (6). Keep adjusting screw (1) from turning and tighten locknut (3). Check that 0.010-inch feeler gage blade still fits snugly between rocker arm pad (5) and intake valve stem (6). If feeler gage does not fit snugly, loosen locknut (3) and do steps 2 through 6 again. Do steps 3 through 6 for cylinder number three and cylinder number six intake valves. GO TO FRAME 5 5-91