TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 661 of 968
TM 9-2815-210-34-2-2 FRAME 2 1. 2. 3. 4. 5. Coat surface of crankshaft damper and pulley assembly (1) which touches front oil seal with lubricating oil. NOTE To avoid overheating and damage to damper pulley (1), use Tempilstick on rim of damper pulley. Heat damper pulley (1) at 200°F for 30 minutes. NOTE To make sure crankshaft damper and pulley assembly is properly seated, put on heated damper and pulley assembly, and put in and tighten retaining screw as soon as possible before temperature of pulley and crankshaft equalize. Aline keyway (2) of damper pulley (1) with damper pulley locator (3). Slide damper pulley (1) on crankshaft (4). Take out damper pulley mounting bolt (5) and damper pulley locator (3). IF END OF CRANKSHAFT (6) IS FLUSH WITH END OF DAMPER PULLEY BORE (7), GO TO FRAME 7. IF END OF CRANKSHAFT (6) IS NOT FLUSH WITH END OF DAMPER PULLEY BORE (7) , GO TO FRAME 3 5-32