TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 654 of 968
TM 9-2815-210-34-2-2 FRAME 2 1. 2. 3. 4. 5. Lightly coat crankshaft hub (1) with lubricating oil. Put crankshaft rear oil seal gasket (2) on rear face of crankcase (3) as shown. Two dowel pins (4) in rear face of crankcase should fit through dowel pin holes in crankshaft rear oil seal gasket. Slide crankshaft rear oil seal housing (5), with rear oil seal inside, over crankshaft hub (1). Using soft-faced hammer, tap oil seal housing so two dowel pins (4) go through dowel pin holes (6) in oil seal housing. NOTE Two lockplates (7) are used only with aluminum crank- shaft rear oil seal housings. Do not put on lockplates unless they were taken off. Put on two lockplates (7) and put in six screws (8) and lockwashers (9). If two lockplates (7) were put on, bend up ends of lockplates so screws (8) do not loosen. END OF TASK 5-25