TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 630 of 968
TM 9-2815-210-34-2-2 CHAPTER 5 FINAL ASSEMBLY Section I. SCOPE 5-1. EQUIPMENT ITEMS engine components into a 5-2. EQUIPMENT ITEMS chapter. COVERED. This final assembly. NOT COVERED. chapter gives All equipment Section II. ASSEMBLY OF NOTE This procedure is the same except where noted. TOOLS: Ring compressor, pn C-10899159 instructions to assemble the items are covered in this ENGINE ASSEMBLY for all engine models -Din-per pulley locator (fabricated locally) Oil pressure regulator valve adapter (fabricated locally) Pilot bolt (fabricated locally) Cylinder head nut wrench, pn D-10951485 Engine transport stand, NSN 4910-00-338-6673 Engine maintenance stand, NSN 4910-00-795-0189 SUPPLIES: Anti-scuff lubricant, Lubrizol 1060 or Texaco TLA111 Sealing compound, type II, MIL-S-45180 Lubricating oil, ICE, OE/HDO 30, MIL-L-2104 Cylinder head gasket (2) Sealant, MIL-S-7916 Crankshaft rear oil seal Crankshaft rear oil seal housing gasket Lubricating oil, ICE, OE/HDO 10, MIL-L-2104 Flywheel housing-to-crankcase gasket Intake and exhaust manifold-to-cylinder head gasket (2) Thermostat housing-to-cylinder head gasket Oil pressure regulator valve housing-to-crankcase gasket Injector pump adapter-to-crankcase gasket Oil cooler gasket and preformed packing set Cylinder head breather tube adapter-to-cylinder head covers gaskets (2) Hydraulic pump-to-crankcase gasket Oil drain gasket Oil inlet adapter gasket Turbocharger-to-exhaust manifold gasket Intake elbow flame heater spark plug gasket Starter mounting gasket (engine LDS 465-2) Starter mounting gasket set PERSONNEL: Two EQUIPMENT CONDITION: All engine components cleaned and ready for assembly 5-1