TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 435 of 968
TM 9-2815-210-34-2-2 b. Cleaning. FRAME 1 NOTE Purpose of agitators to stir cleaning compound while it is boiling. These steps for fabrication of agitator are general and may be altered if necessary. 1. Cut about two feet of copper tube (1) and seal one end (2) by flattening with hammer. 2. Coil tube (1) as shown and drill small holes (3) about 1/2 inch apart along underside of coiled end. 3. Put fitting (4) on other end of tube (1). GO TO FRAME 2 4-416