TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 330 of 968
TM 9-2815-210-34-2-2 FRAME 2 1. 2. 3. Using hammer and blunt chisel, drive damaged ring gear (1) from flywheel (2). WARNING Use welder’s gloves when handling hot ring gear (3). CAUTION Do not use cutting torch to heat ring gear (3). Use heating torch to avoid damage to gear. Do not heat ring gear to more than 400°F. Temperatures above 400°F will soften gear. Use Tempilstick to measure heat. Using heating torch, heat inner surface of new ring gear (3) until 400°F. Tempilstick melts when touched to side of new ring gear. Using hammer and brass drift, quickly drive heated ring gear (3) onto flywheel (2). END OF TASK 4-311