TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 283 of 968
TM 9-2815-210-34-2-2 FRAME 5 NOTE Readings must be within limits given in table 4-57. The letter L shows a loose fit. If readings are not within given limits, throw away part and get a new one. Rear end of rocker arm shaft (1) has a locating dowel pin (2). Rocker arm bearing surfaces of rocker arm shaft (1) are surface areas near the first, third, fourth, fifth, sixth, and eighth oil holes in rocker arm shaft, counting from front to rear. Bearing surfaces will look shiny on used rocker arm shafts. 1. Measure inside diameter of six rocker arm bearings (3). Note each measurement and which rocker arm it was taken on. 2. Measure outside diameter of six rocker shaft (1). Note each measurement and was taken on. 3. Measure fit of each rocker arm bearing arm shaft (1). arm bearing surfaces of rocker arm which rocker arm bearing surface it (3) on its bearing surface of rocker 4. Measure length A of six valve adjusting screws (4). GO TO FRAME 6 4-264