TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 236 of 968
TM 9-2815-210-34-2-2 FRAME 7 1. 2. 3. 4. 5. Lay a straight edge (1) along line A on gasket surface of cylinder head (2). Using feeler gage, check that gasket surface of cylinder head is not out-of- flat crosswise. If gasket surface of cylinder head (2) is more than 0.003 inch out-of-flat crosswise, get a new cylinder head. If gasket surface is out-of-flat by less than 0.003 inch crosswise, tag cylinder head for resurfacing by reaching shop. NOTE Cylinder head (2) may have been resurfaced before. If cylinder head was resurfaced before, amount of metal machined off will be stamped on front of cylinder head about 1/2 inch from gasket surface of cylinder head. No more than 0.005 inch can be machined off. If 0.005 inch has already been machined off and cylinder head needs resurfacing, get a new cylinder head. Lay straight edge (1) along line B on gasket surface of cylinder head (2). Do steps 1 and 2 again. Lay straight edge (1) along line C on gasket surface of cylinder head (2). Do steps 1 and 2 again. Lay straight edge (1) along line D on gasket surface of cylinder head (2). Do steps 1 and 2 again. GO TO FRAME 8 4-217