TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 144 of 968
TM 9-2815-210-34-2-2 FRAME 5 1. 2. NOTE Readings must be within limits givien in table 4-29. The letter L shows a loose fit. If readings are not within given limits, throw away part and get a new one. Cylinder sleeves (1) can be a little bit out-of-round before they are put in cylinder bores in crankcase (2). Because of this, it is not practical to measure cylinder sleeve diameter when cylinder sleeves are out of cylinder bores. Outside diameter of cylinder sleeves and fit of cylinder sleeves in cylinder bores is given in table 4-29 for reference purposes only. Measure inside diameter of six cylinder sleeves (1) inside crankcase (2). Take measurement one inch from top of cylinder sleeve. Turn crankcase (2) upside down. END OF TASK Index Number 1 l and 2 1 Table 4-29. Cylinder Sleeve Wear Limits Size and Fit of New Parts Item/Point of Measurement (inches) Cylinder sleeve outside diameter 4.7500 to 4.7510 Fit of cylinder sleeve in bore of crankcase 0.0005L to 0.0015L Cylinder sleeve inside diameter (cylinder sleeve in crankcase) 4.5630 to 4.5645 Wear Limit (inches) None None 4.5665 4-125