TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 143 of 968
TM 9-2815-210-34-2-2 FRAME 4 1. 2. 3. 4. NOTE No special tools are needed to put in cylinder sleeves (l). If old cylinder sleeves are used again, they must be put back in the same cylinder bore (2) they were taken from. Coat six cylinder sleeves (1) with engine lubricating oil and put one into each of six cylinder bores (1). Y-size cylinder sleeves must go in Y-size cylinder bores. Z-size cylinder sleeves must go in Z-size cylinder bores. Using block gage, measure and note height of top of each cylinder sleeve (1) from top surface of crankcase (3). Cylinder sleeve is properly seated when this height is 0.0005 to 0.005 inch. If height is more than 0.005 inch, push cylinder sleeve further in. Subtract biggest and smallest measurement done on three cylinder sleeves (1) closest to front of crankcase (3). Difference should not be more than 0.002 inch. If difference is bigger, push highest cylinder sleeves further down and check heights again. Do step 3 again for the three cylinder sleeves (1) closest to rear of crankcase (3). GO TO FRAME 5 4-124