TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 126 of 968
TM 9-2815-210-34-2-2 FRAME 4 1. 2. 3. 4. Check that neither face of camshaft thrust plate (1) is worn thin in places. Check that neither face of camshaft thrust plate has grooves worn in it. If either face of camshaft thrust plate (1) is groooved or badly worn down, throw it away and get a new one. WARNING Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when solvent is used. Use only in well-ventilated places. Failure to do this may result in injury to personnel and damage to equipment. Check that neither face of camshaft thrust plate (1) has small nicks, scratches or burrs. To fix small nicks, scratches, and burrs, put crocus cloth soaked in dry cleaning solvent on a flat surface. Then rub face of camshaft thrust plate against crocus cloth. Measure thickness of camshaft thrust plate (1) near hole in center. Reading must be within limits given in table 4-20. If readings are not within given limits, throw away camshaft thrust plate and get a new one. GO TO FRAME 5 Table 4-20. Camshaft Thrust Plate Wear Limits Size and Fit Index of New Parts Wear Limit Number Item/Point of Measurement (inches) (inches) 1 Camshaft thrust plate thickness 0.2400 to 0.2420 0.2380 4-107