TM-9-2815-210-34-2-2 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 2
Page 106 of 968
TM 9-2815-210-34-2-2 FRAME 63 1. 2. 3. 4. 5. NOTE Main bearing caps (1) with bearing halves (2) and main bearing saddles (3) are called by numbers one to seven counting from front to rear of crankcase (4). Number three, number five, and number six main bearing caps (1) look the same. They are marked with their number. Put number three main bearing cap (1) with bearing half (2) on number three main bearing saddle (3). Mounting holes in number three main bearing cap must line up with screw holes in number three main bearing saddle. Coat two bolts (5) and washers (6) lightly with engine lubricating oil. Put in and hand tighten two bolts and washers. Using torque wrench, tighten two bolts (5) to 80 to 90 pound-feet. Using torque wrench, tighten two bolts (5) to 115 to 120 pound-feet. Do this frame again for number five main bearing cap with bearing half and number six main bearing cap with bearing half. GO TO FRAME 64 4-87