TM-9-2815-210-34-2-1 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 1
Page 193 of 259
TM 9-2815-210-34-2-1 NOTE Tell machine shop to make pilot stud (1). See figure 3-3. 1. Put pilot stud (1) in hole of flywheel (2) as shown. Soldier A 2. Using engine barring tool, hold crankshaft damper and pulley (3) so it cannot turn to the right. Soldier B 3. Hold flywheel (2) against crankshaft so it will not fall when lock- bolts (4) are taken out. While holding flywheel against crankshaft, take out five lockbolts (4). Soldiers 4. Hold up flywheel (2) and slide it back clear of pilot stud (1) and A and B take it off. Set flywheel down on wooden blocks. Soldier A 5. Take out pilot stud (1). END OF TASK TA 087690 3-145