TM-9-2815-210-34-2-1 LDS-465-1/LDS-465-2 Multifuel Engine Maintenance Manual Part 1
Page 177 of 259
Section III. DISASSEMBLY OF NOTE TM 9-2815-210-34-2-1 ENGINE ASSEMBLY This procedure is the same for all engine models except where noted. TOOLS: Engine transport stand, NSN 4910-00-338-6673 Engine maintenance stand, NSN 4910-00-529-8387 Puller, NSN 5120-00-134-7463 Puller kit, pn 8708724 Plug, pn 10899178 Wood block, 2x4x18 inches (2) Brass rod SUPPLIES : Lacquer, nitrocellulose, type I, TT-L-50 Tool tags Wire Steel bar stock Bolt (2) Tags PERSONNEL : TWO EQUIPMENT CONDITION: Engine mounted on transport stand. 3-31. MOUNTING ENGINE ON MAINTENANCE STAND. a. Preliminary y Procedures. (1) Remove engine from shipping container and place on transport stand. Refer to para 2-3 through para 2-5. (2) Remove generator and mounting bracket. Refer to para 3-4. (3) Remove crankcase breather adapter. Refer to para 3-19. (4) If engine is equipped with a turbocharger, remove turbocharger. Refer to para 3-5. (5) Remove oil pressure regulator valve. Refer to para 3-24. (6) Remove air compressor and mounting bracket. Refer to para 3-12 and 3-17. (7) Remove fuel filter and mounting bracket. Refer to para 3-14. (8) If engine is equipped with hydraulic pump, remove hydraulic pump. Refer to para 3-13. (9) Remove fuel injector pump and fuel injector lines. Refer to para 3-10 and 3-8. (10) Remove oil filter and mounting bracket. Refer to para 3-11 and 3-15. (11) Remove oil cooler and oil cooler water hose. Refer to para 3-15. (12) Remove tappet chamber covers. Refer to para 3-16. (13) Remove intake and exhaust manifolds. Refer to para 3-30. 3-129