TM 9-2520-246-34 Figure 4-38. Input Shaft (3) Place the high-speed gear in a press and press high-speed gear ball bearings and high-speed gear bearing spacer from the bore of the high-speed gear. (See fig. 4-38.) Apply pressure to the inner race of the bearing only. (4) Slide synchronizer assembly from the input shaft. (See fig. 4-38.) (5) Place the input shaft assembly in an arbor press, front bearing up. (See fig. 4-38.) Place support bars beneath the low-speed gear, and press the low- speed gear, gear bearing, thrust washer, and front bearing from the shaft. (6) Place the low-speed gear in a press and press low-speed gear bearings, and gear bearing spacer from low-speed gear. (See fig. 4-38.) Apply pressure to the inner race of the bearing only. Disassembly — Exploded View. d. Front Output Shaft. NOTE Before installing the inner race and shaft drive gear onto the shaft, coat the front output shaft with white lead pigment, Fed Spec TT-W-261C. (1) Remove the reverse shifter shaft fork from the reverse shift collar. (See fig. 4-39.) (2) Aline both of the outer races and slip the reverse shift collar from the shaft assembly. (See fig. 4-39.) (3) Remove the snapring and spacer and slip front outer race from the shaft assembly. (See fig. 39.) Figure 4-39. Front Output Shaft Disassembly — Exploded View. the 4- 4-26