TM 9-2520-246-34 rear bearing cover capscrews to 60-77 lb-ft torque. Refer to section VII of this chapter for bearing adjustment procedures. Remove the four capscrews and lockwashers securing the idler shaft rear bearing cover to the transfer case. (See fig. 4-35.) Remove the cover and rear bearing shims. o. Input Shaft Rear Bearing Cover. Figure 4-34. Removal of Transfer Top Cover and Shifter Shaft. n. Idler Shaft Rear Bearing Cover. NOTE During assembly, tighten the idler shaft NOTE During assembly, use a new gasket. Tighten capscrews to 60-77 lb-ft torque. NOTE Remove the six capscrews and lockwashers securing the input shaft rear bearing cover to the transfer case. (See fig. 4-35.) Remove the rear bearing cover and gasket; discard the gasket. Figure 4-35. Removal of Rear Output Shaft Rear Bearing Cover, Idler Shaft Rear Bearing Cover, and Input Shaft Rear Bearing Cover. 4-24