TM 9-2520-246-34 Figure 4-24. Repair and Replacement Standard Points of Measurement for Transfer Output Shaft and Cover. Table 4-3. Repair and Replacement Standard Points of Measurement for Transfer Output Shaft and Cover Fig. Ref. Point of Measurement Size and Fit No. Letter Wear Limits of New Parts 4-24 A Clutch shifter shaft outside diameter 0.8715-0.8725 0.8685 4-24 B Clutch shifter shaft case bore 0.8745-0.8765 0.8800 4-24 A-B Fit of clutch shifter shaft in bore 0.0030L-0.0040L 0.0115L 4-24 C Front axle output shaft bearing case bore 3.3463-3.3473 3.3483 4-24 D Bearing outside diameter 3.3459-3.3465 4-24 C-D (*) Fit of bearing in front axle output shaft bearing case bore 0.0024L-0.0002T .0024L 4-24 E Companion flange inside diameter 1.621-1.624 1.627 4-24 F Front axle output shaft outside diameter 1.621-1.623 1.619 4-24 E-F Fit of flange on shaft 0.0020T-0.0030L 0.0073L 4-24 G Bearing inside diameter 1,7712-1.7717 (*) 4-24 H Front axle output shaft outside diameter 1.7716-1.7721 1.7716 4-24 G-H Fit of bearing on shaft 0.0009T-0.0001L 0.0001L 4-17