TM 9-2520-246-34 Figure 4-19. Front Output Shaft Cover Disassemble. g. Handbrake Shoe Assembly. NOTE Sometimes the handbrake shoes are not worn enough to warrant replacement. Replace lining when worn to within 1/16 inch of rivet head. Worn shoe linings can result in injury to personnel and damage to vehicle. Refer to TM 9-2320-209-20/1 for adjustment. (I) Remove the two snaprings holding the handbrake lever pins in position. (See fig. 4-21.) (2) Remove the two slotted washers holding the stabilizer spring in position and remove the brake stabilizer spring and pin. (3) Remove the handbrake shoe lever and lever pins. (See fig. 4-2l.) Figure 4-20. Transfer Case Disassembly. Figure 4-21. Disassembly of Handbrake Shoe Assembly. Replacement brakeshoes must be drilled for rivet holes. Be sure to wear a mask to prevent asbestos dust particles from entering lungs. Drilling must be done in a well-ventilated area away from unprotected personnel. Eyeshields must also be worn during drilling operation. Failure to observe these precautions may result in injury to personnel. (4) If replacement is necessary, remove the sixteen (16) rivets securing the lining to the inner and outer brakeshoes of 4-21.) 4-7. a. b. c. d. e. f. g. Assembly of the handbrake assembly. (See fig. Subassemblies (Sequence). Hand brake (fig. 4-21). Transfer case (fig. 4-20). Front output shaft cover (fig. 4-19). Transfer case cover (fig. 4-17 and 4-18). Input shaft (fig. 4-16). Countershaft (fig. 4-15). Rear output shaft (fig. 4-14). 4-10