TM 9-2520-246-34 interruptions. ICE, MIL-L-2104. Allow the seal to soak for 45 minutes before installation. (4) When preparing a new oil seal for assembly, place it in a small container of lube oil (OE/HDO 10) 2-11. Lubrication. Refer to LO 9-2320-209-12/1 for lubrication instructions. Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS AND ASSEMBLIES 2-12. General. This section provides procedures for the removal and installation of the following major components and assemblies: transmission, transfer, and power takeoff assemblies. 2-13. Transmissions, Models 3052 and 3053A. Refer to TM 9-2320-209-34 for multifuel engine powered vehicles or TM 9-2320-209-20 for gasoline powered vehicles. 2-18 2-14. Transfer, Models T-136-21 and T-136-27. Refer to TM 9-2320-209-34 for multifuel engine powered vehicles or TM 9-2320-209-20 for gasoline engine powered vehicles. 2-15. Power Takeoffs, Models WN-7-28, WND- 7-28, and P-136-C. Refer to TM 9-2320-209-34 for multifuel engine powered vehicles or TM 9-2320-209- 20 for gasoline engine powered vehicles.