TM 9-2520-246-34 Figure 5-32. Removal of Output Shaft Rear Bearing Retainer and Oil Seal. d. Output Shaft. Use a soft drift pin and hammer to drive the output shaft and both bearings from the carrier. (See fig. 5-33.) Removal of the output shaft will also remove the rear tapered roller bearing cup. Figure 5-33. Removal of Output Shaft, Both Bearings, and Rear Tapered Roller Bearing Cup. e. Output Shaft Front Bearing Cup. Place the carrier and front bearing cup in an arbor press. (See fig. 5-34.) Press the cup from the carrier. NOTE Upon assembly, make sure the bearing cup is installed with the taper of the cup facing toward the center of the carrier. f. Output Shaft. Using an arbor press, press the governor drive gear, rear bearing, and front bearing from the output shaft. (See fig. 5-35.) Figure 5-34. Removal of Output Shaft Front Bearing Cup. NOTE Upon assembling the output shaft, make sure rear bearing, governor drive gear, and front bearing are installed as shown in fig. 5-35. Figure 5-35. Disassembly of Output Shaft. 5-27. Assembly Sequence. a. b. c. d. seal. e. f. Assembly of output shaft. (See fig. 5-35.) Output shaft front bearing cup. (See fig. 5-34.) Output shaft. (See fig. 5-33.) Output shaft rear bearing cup, retainer, and oil (See fig. 5-32.) Pump and shifter shaft. (See fig. 5-30 and 5-31.) Drain plug and shift lever. (See fig. 5-29.) 5-19