TM 9-2520-246-34 NOTE Figure 5-21. Housing Removal of Rear Output Shaft Shifter Shaft Retainer, Ball, and Spring. c. Rear Output Shaft and Sliding Clutch Sleeve. (1) Using a pair of snapring pliers, remove the output shaft snapring securing the shaft to the bearing. (See fig. 5-23.) Figure 5-22. Removal of Shifter Shaft and Shifter Shaft Fork. (2) Place the rear output shaft housing in a vise. Using a soft drift pin, drive the rear output shaft from the housing and remove the sliding clutch sleeve. (See fig. 5-24.) d. Rear Output Shaft Bearing and Shifter Shaft Boot and Oil Seal. (1) Using a pair of snapring pliers, remove the bottom and top snaprings securing the rear output shaft bearing in the housing and remove the bearing. (See fig. 5-25.) (2) Using a suitable tool, drive the shifter shaft oil seal and boot from the housing. (See fig. 5-25.) When installing the shifter shaft boot and oil seal, press the oil seal in part way and fit the boot around the seal, then continue to press the seal into position. Figure 5-23. Removal of Output Shaft Snapring. Figure 5-24. Removal of Rear Output Shaft and Sliding Clutch Sleeve. 5-13