TM 9-2520-246-34 Figure 5-9. Removal of Output Shaft Rear Bearing. f. Output Shaft Rear Bearing. (1) Push or tap output shaft rearward enough to allow the rear bearing (fig. 5-9) to be removed. (2) Using a universal puller remove the output shaft rear bearing. (See fig. 5-9.) NOTE Use a wooden block or press to install rear bearing on the shaft and into the rear bearing bore. g. Output Shaft and High-Speed Gear. (1) After the output shaft rear bearing is removed, push the output shaft back into place. Remove the snapring securing the high-speed gear and Figure 5-11. Removal of Output Shaft, High-Speed Gear, and Front Bearing. spacer. (See fig. 5-10.) (2) Push or tap the output shaft and front bearing from the case. (See fig. 5-11.) Lift the sliding gear out of the case. h. Reverse Gear. (1) Remove the cotter pin securing the reverse gear pin and remove the reverse gear pin. (See fig. 12.) 5- (2) Using a soft drift pin, tap the reverse gearshaft and front roller bearing from the case. Remove the front roller bearing from the shaft. (3) Remove the reverse gear thrust washers (fig. 5-12). Figure 5-10. Removal of Output Shaft High Speed Gear Snapring and Spacer. Figure 5-12. Removal of Reverse Gear. 5-5